Convert Parts per Million to Grains per Gallon (UK)
Part per Million (ppm) to Grain per Gallon (UK) (gr/gal(UK)) solution concentration conversion — enter any value below to get an instant result, or use the table for common values.
Results from this calculator are estimates provided for general informational purposes only, based on formulas, rates, and standards commonly accepted as of 2026. Figures may differ slightly from other calculators or professional sources due to rounding methods, differing assumptions, or regional regulations, and rules may change over time. Always consult a qualified professional — such as a financial advisor, healthcare provider, or other relevant specialist — before making decisions based on these results.
Result
1 ppm = 0.070076681 gr/gal(UK)
1 Part per Million = 0.070076681 Grains per Gallon (UK)
1 Grain per Gallon (UK) = 14.270082 Parts per Million
1 ppm in every supported unit
Conversion chart: Part per Million to Grains per Gallon (UK)
Conversion table
| Part per Million (ppm) | Grain per Gallon (UK) (gr/gal(UK)) |
|---|---|
| 0.01 ppm | 0.00070076681 gr/gal(UK) |
| 0.1 ppm | 0.0070076681 gr/gal(UK) |
| 1 ppm | 0.070076681 gr/gal(UK) |
| 2 ppm | 0.14015336 gr/gal(UK) |
| 3 ppm | 0.21023004 gr/gal(UK) |
| 5 ppm | 0.35038341 gr/gal(UK) |
| 10 ppm | 0.70076681 gr/gal(UK) |
| 20 ppm | 1.4015336 gr/gal(UK) |
| 50 ppm | 3.5038341 gr/gal(UK) |
| 100 ppm | 7.0076681 gr/gal(UK) |
| 1000 ppm | 70.076681 gr/gal(UK) |
Part per Million (ppm)
Definition: A dimensionless ratio expressing one part of solute per million parts of solution by mass; on this page it is treated on a mass basis, which for dilute aqueous solutions works out to approximately 1 mg/L since a liter of water weighs close to one kilogram.
History: Popularized in analytical chemistry and environmental science as a convenient way to express very small concentrations without long strings of decimal zeros, though its exact conversion depends on whether it is applied on a mass, volume, or mass/volume basis.
Current use: Ubiquitous in water-quality reporting, air- and soil-contaminant limits, and food-safety regulations — but always worth confirming which basis a given ppm figure uses before treating it as interchangeable with mg/L.
Grain per Gallon (UK) (gr/gal(UK))
Definition: The same grain-based concentration measure as its US counterpart, but referenced to the larger UK (imperial) gallon, giving a slightly different numeric conversion factor.
History: Developed alongside British water-hardness testing standards using the imperial gallon, which is about 20% larger than the US gallon, producing a lower grains-per-gallon figure for the same actual concentration.
Current use: Occasionally seen on older or UK-sourced water-hardness charts and softener specifications, though most UK water utilities today report hardness in mg/L or degrees Clark.
Supported Units
| Unit | Symbol | In kg/L |
|---|---|---|
| Kilogram per Liter | kg/L | 1 kg/L |
| Gram per Liter | g/L | 0.001 kg/L |
| Milligram per Liter | mg/L | 1E-06 kg/L |
| Part per Million | ppm | 9.98859E-07 kg/L |
| Grain per Gallon (US) | gr/gal(US) | 1.71181E-05 kg/L |
| Grain per Gallon (UK) | gr/gal(UK) | 1.42538E-05 kg/L |
| Pound per Gallon (US) | lb/gal(US) | 0.11982643 kg/L |
| Pound per Gallon (UK) | lb/gal(UK) | 0.099776374 kg/L |
| Pound per Million Gallon (US) | lb/Mgal(US) | 1.19826E-07 kg/L |
| Pound per Cubic Foot | lb/ft³ | 0.016018463 kg/L |
About These Parameters
- Value
- The solution concentration value you want to convert, expressed in the "From" unit. Accepts decimals.
- From Unit
- The unit your input value is currently measured in — a water-quality report's mg/L, or a hardness test kit's grains per gallon.
- To Unit
- The unit you want the result converted into. Use the swap button to flip From and To instantly.
How Concentration - Solution Conversion Works
The Formula
Every unit here is defined by a fixed multiplier relative to kilograms per liter. To convert a value from one unit to another:
result = value × (factor of "From" unit ÷ factor of "To" unit)
For Part per Million → Grain per Gallon (UK): multiply by 0.070076681. For example, 1 ppm × 0.070076681 = 0.070076681 gr/gal(UK).
Solution Concentration vs. Molar Concentration
This page covers MASS-basis concentration — mass of solute per unit volume of solution, such as mg/L or lb/gal. The site's separate Concentration - Molar Converter covers MOLE-basis concentration (e.g. moles per liter, "molarity"), which counts particles of solute rather than their mass. Converting between the two requires knowing the solute's molar mass: dividing a mass-basis concentration by the molar mass gives the mole-basis concentration, and multiplying a mole-basis concentration by the molar mass gives the mass-basis figure back.
Understanding Water Hardness
Grains per gallon and parts per million (ppm) are the two units the water-treatment industry relies on to describe hardness — the concentration of dissolved calcium and magnesium minerals in water. One grain per gallon (US) equals roughly 17.1 mg/L (approximately 17.1 ppm on a mass basis), and water-softener systems are typically sized in "grains of capacity" against a measured grains-per-gallon hardness figure. Water below about 1 gr/gal is considered soft, while water above 10-15 gr/gal is considered very hard.
Example
A solution concentration of 1 ppm equals 0.070076681 gr/gal(UK). For scale, US drinking-water standards generally set contaminant limits in the low single-digit mg/L range, while a moderately hard tap water might test around 7-10 grains per gallon (roughly 120-170 mg/L of hardness minerals).
Frequently Asked Questions
How many Grains per Gallon (UK) are in 1 Part per Million?
1 Part per Million (ppm) equals exactly 0.070076681 Grains per Gallon (UK) (gr/gal(UK)).
What does ppm mean in water testing?
In water testing, ppm (parts per million) is almost always used on a mass basis, meaning one milligram of solute per kilogram (roughly one liter) of water — which is why ppm and mg/L are treated as effectively interchangeable for dilute aqueous solutions, even though the two units are defined differently in principle.
What's a grain per gallon?
A grain per gallon (US) is a traditional water-hardness unit equal to one grain (1/7,000 of a pound) of dissolved mineral per US gallon of water, roughly 17.1 mg/L — it remains the standard unit on US water-softener sizing charts and hardness test strips even though most other concentration measurements have moved to metric mg/L.
How accurate are these conversions?
Every conversion factor used here is the standard, internationally recognized relationship between the underlying mass and volume units — results are limited only by floating-point display precision, not by rounded conversion constants.